I have to be honest with you. I wasn't going to share this one. It was just too good. What if I let this cat out of the bag and everybody and their grandmother started cashing in on it? What then? But then I figured, what the hell? It's not like I do a lot of work these days and spend a lot of time on this one. Sure, I intend to dabble a bit, but full time? No way in hell. I'd much rather be playing video games and Magic the Gathering. So for the rest of us working stiffs, this one's for you.

Frozen pipes may be somewhat common in the wintertime. If your pipes do freeze, you want to check and see if the pipes are busted or cracked. If your pipes are frozen, you can use a hair dryer to try and thaw out the pipes. However, if this will not work, you will need to call in a drain leak who may either try and thaw the lines out another way or they may just end up replacing the section of the line that is broken.

Water leak detectors are alarms that alert you of leaks. They do not stop the water leak from happening. They also do not stop the leak after it happens or turn off the water line repair valve. You will still need to turn off the water valve yourself and contact a Utah plumber to come check out the plumbing issue.



Leaks can occur anywhere in your reverse osmosis water filter system. If this ever occurs, check the source of the leak. It may be from the hoses, fittings and the valves. Most of the time, some kind of tightening might be necessary. So make sure to securely tighten the fittings. If this does not work, you may need to replace the filter itself, however that might take a bit more work.

The location of a plumbing contractor is a key factor. This is because he or she will not only charge you an hourly rate, but travel costs will also be charged. This can add a significant amount to the final bill if the contractor has to travel from the other side of town.

Remove the cap of the faucet using slip-joint pliers. Tape the teeth of the pliers to prevent damage of the surface. Remove the faucet cam washer and water line repair the rotating ball.

There are a lot of different shapes and styles of toilets but, with a few exceptions, they all work about the same. Water is released from the tank (many commercial toilets use a special valve instead of a tank) into the bowl to flush the waste into your drainage piping. Basically pretty simple, right?

Then, you can take your new shower parts home and reinstall them in the inner assembly. It is very important that everything be aligned properly and tightened to prevent leaks. Beware of over tightening, however, since this can also cause problems. Once you are sure everything is installed properly, replace the cover plate and turn the water back on to test your repair work. With a little bit of work, your do-it-yourself shower repair project can be a success. It does not take an expert, just a little effort and know how.